No plugs in the top of the strutIe, here’s an example from my gap iid showing the suspension re calibration screen
also curious regarding the anti roll bar dynamic system , are there connectors that plug into the top of the struts plse
View attachment 295147
The air system drained itself with the airbag being blown, so it was on bump stops. Jacked car up on jacking points, supported underneath by axle stands just in case, removed complete leg, refit new leg and lowered back to floor. Exactly like I did 4weeks earlier on other front leg. With no issues.
As I put in the actual value of measurement into the calibration program the icarsoft cancelled the operation, I wonder if I put in the lowest values except able it would recharge the system
I just jacked it up as I didn't think I needed to as I thought it's not an electrical component (how wrong I was) I think it stems down to the front bag blowing midway of calibration on icarsoft, extended mode I think it said before scaring the life out of me with a bang. That's on the info screen, and as I turn the key to on....suspension fault 30mph
thks , I know that if the wrong measurement's are specified the ECU will not allow them , along with if the module has become corrupted , hopefully that’s not the case , is there any lights where the height control dial is plse
have u tried foot on the brake , engine running , then moving the dial anti clockwise and holding it there for 5 x seconds to see if anything happens
Plus wonder if u could try and put a 12 Vdc supply to the compressor it self to get it off the bump stops
can u remember what measurements u we’re putting into the diagnostics plse
fear that you’ve either corrupted the ecu, or damaged one of the height sensors , lastly have u measured the Vdc of ur battery plse as that needs to be fully charged
hope that may help
This control switch
There is no terain modes and no lights on the raise and lower switch.
At this moment in time I just need to get some air into all 4 corners so I can drive it. I actually don't care about the correct running settings, I need the car off the bump stops....if you know where I'm coming fromThere is no terain modes and no lights on the raise and lower switch.
I have a secondary backup battery so I'll disconnect both leave for a while and see where that leadsthks, so indeed that means the ecu is disabled so that needs to be reactivated
will the diagnostics allow to to reset it, another thing is if u disconnect both battery leads , ensuring they don’t touch the battery itself is to touch both leads together for 5 x mins on the hope of it resetting everything
Would a gap ii2 do the trickthks, so indeed that means the ecu is disabled so that needs to be reactivated
will the diagnostics allow to to reset it, another thing is if u disconnect both battery leads , ensuring they don’t touch the battery itself is to touch both leads together for 5 x mins on the hope of it resetting everything
if that doesn’t work have u double checked all the relevant fuses with a multimeter plse
if all ok will need a better diagnostics to be able to reset everything
alas not sure if the Autel ap200 will work , many of us own the gap iid but are locked to the vehicle , shame ur not closer as I have a Autel mx808 which would have certainly helped
At this moment in time I just need to get some air into all 4 corners so I can drive it. I actually don't care about the correct running settings, I need the car off the bump stops....if you know where I'm coming from