discomark10
Well-Known Member
Thought you had the pipes done underneath?
200tdi ayre
Well-Known Member
I did for the old transfer box but the viscous is a lot closer to the chassis and so the old pipes don't fit
I've worked out where to put them but actually doing it is going to be fun
discomark10
Well-Known Member
Ah I see, I had no room under mine at all, was a right pita to sort!
200tdi ayre
Well-Known Member
The plan is 1 over the top of the engine one behind the sump then join up, go below the floor on the passenger side and into the tub below the rad
200tdi ayre
Well-Known Member
Nice mate
Could use rubber pipe for cooling or is it too expensive?
Boats have rubber all over the show, no problems there, guess hard pipe is cheap though...
Yeah basically you want lots of cooling available!
Using steel for the straight bits with rubber connectors and joins, easier to make and secure and more sturdy too
200tdi ayre
Well-Known Member
Water today, been going for about an hour and a half and it's almost done just the back pipes to do and paint
Ill post a pic when it's done then I've gotta tackle wiring and fuel
just the back pipes to do and paint Ill post a pic when it's done then I've gotta tackle wiring and fuel
discomark10
Well-Known Member
I love the wiring bit! wish there was more to do!
200tdi ayre
Well-Known Member
Here it is
Still have to secure it and fettle a little but you get the idea
Still have to secure it and fettle a little but you get the idea
discomark10
Well-Known Member
might be worth adding some shielding to the bits underneath, also your gona need to add a bleed to the one above the plenum
But looking good!
But looking good!
200tdi ayre
Well-Known Member
Yeah ill add a bleed to the pipe (piece of ****) and the rest is above chassis rails so is quite well protected but that's something I'll definately look at
I will have a crossmember but ill have to make one and ill make it to fit around what's there and to protect everything so that'll be the last job
200tdi ayre
Well-Known Member
I don't really need to
Just gotta make a top for the selector and make sure the high low lever has space
200tdi ayre
Well-Known Member
There's not a lot of space anyway
Plus I'd have to start cutting away at the seat box and it's just a lot of work
Plus ill have destroyed my exhaust 4 inches before hand and the pipes are over half a metre off the ground and above the chassis rails and transfer box so I'm not too worried
200tdi ayre
Well-Known Member
Pipes everywhere !!
