A

ANGELO DAMATO

New Member

• Dec 12, 2010

• #1

Hi guys you all out there, here is my little problem end your advice is allway welcome my landy is a110 200tdi done 205.000 so i thought il change its belt having done it once all ready at 112.000km.So all done torqued as the good Original LR book says inc tensioner put back togeather starts on the button goes ok and the dam'n thing squeaks and by the sound of it its per eng revolution [ie] 2cam to1crank revs.And to cap it all when engine in warm it all most disapears.So i thought il ask your thoughts. shall i leave it alone? or take it to bits again? having allready done about 15 km trying it. problems problems:doh:

 

S

Sean

Banned

• Dec 12, 2010

• #2

what make kit did you use ?

 

A

ANGELO DAMATO

New Member

• Dec 12, 2010

• #3

Dayco belt and britpart tensioner. had a good look see at the tensioner and looked ok as far as quality goes Dayco was the belt i used the first time i did it and to be honest it looked ok when i took it apart yesterday but i thought il change it to be on the safe side means it's done it's Miles

 

A

aaron1980

New Member

• Dec 12, 2010

• #4

sunds like the belt maybe a little tight.

 

A

ANGELO DAMATO

New Member

• Dec 12, 2010

• #5

You may have e point there allthough i torqued the tensioner with a dial type T wrench and i never trust them to be frank .The question is do i leave it end hope it beds in by doing some miles? or take it apart.....

 

S

Sean

Banned

• Dec 12, 2010

• #6

ANGELO DAMATO said:

Dayco belt and britpart tensioner. had a good look see at the tensioner and looked ok as far as quality goes Dayco was the belt i used the first time i did it and to be honest it looked ok when i took it apart yesterday but i thought il change it to be on the safe side means it's done it's Miles

Click to expand...

the belt will be just fine .....

 

A

ANGELO DAMATO

New Member

• Dec 12, 2010

• #7

Thanks Sean i think il leave it alone and se how it sounds after a couple of days and about [160 km] thats two days to work and back. Aaron might be right ,se if it'll bed /setle in.

 

Jason2

Well-Known Member

• Dec 13, 2010

• #8

Don't rule out the crankshaft pulley damper! They make racket when the rubber starts going. Only about 45 snakes.

 

A

ANGELO DAMATO

New Member

• Dec 13, 2010

• #9

Good point jason must say never thought of that one, gues i can run the motor in the yard with the B puley off to see how it sounds means it does it all the time, on the other hand if it was that would the squeaking allmost go when the engine is warm? cos that's what it does..

 

Jason2

Well-Known Member

• Dec 13, 2010

• #10

Mine was squeaking on and off like yours and mainly from cold, when I took the crank pulley off I could see the rubber damper bit breaking up.

I also originaly thought that it was one of the timing belt pulleys cos I've had one go too and it makes approx the same noise.

Good Luck