We'd gone to périgueud at the weekend. I'd installed new height sensors at the rear so now à full set done and it did nothing but ef about at 70mph.....at 56mph not a problem and all quiet... All connections soldered and sealed and I don't understand it.
Checked with my Nano and all the settings are totally uneven and buggered up??? I've just had the eas ecu out and totally dry and clean.. All plugs are good and tight and clean... So... Reset the height settings and it's as good as gold.... So until it goes on the motorway I guess I have to wait and see.... Other than that... It's the best 4x4 by far:cool:
And checked my levels :D
Are some of your height settings too close to the limit set by firmware causing them to revert to defaults I wonder?
 
Are some of your height settings too close to the limit set by firmware causing them to revert to defaults I wonder?
I had thought that also. I did a reset and it did continue. I have also just replaced the driver pack you kindly repaired for me... So watch this space and see if it was a commis problem.. o_O
 
Cleaned it :)

2NhPmgI.jpg

DSCN3153 2NhPmgI
 

Similar threads