H

hubbs44

New Member
Hi

Yesterday i connected my trailer and tested the lights before setting off only to find the left indicator on the vehicle comes on correct but the right indicator comes on the trailer..... and the otherside is the same.

Some have said it could be an earthing issue but any help where these are located so i can check? - or other suggestions to check?

thanks
 
hubbs44 said:
Hi

Yesterday i connected my trailer and tested the lights before setting off only to find the left indicator on the vehicle comes on correct but the right indicator comes on the trailer..... and the otherside is the same.

Some have said it could be an earthing issue but any help where these are located so i can check? - or other suggestions to check?

thanks
Click to expand...
Did it work properly before?
The bundle of connections are inside the back door, drivers side, behind the little diagonal cover panel, which will need to be removed. It might just be a case of swapping the left and right hand connections.
 
Al2O3 said:
Did it work properly before?
The bundle of connections are inside the back door, drivers side, behind the little diagonal cover panel, which will need to be removed. It might just be a case of swapping the left and right hand connections.
Click to expand...

Hi, yes it worked fine before, but going on what you mentioned that drivers side panel fell off a week before this happened......sounds like it could be connected
 
hubbs44 said:
Hi, yes it worked fine before, but going on what you mentioned that drivers side panel fell off a week before this happened......sounds like it could be connected
Click to expand...
It certainly does. Especially if the cables were tucked neatly back together to get the cover back on. They're bullet connectors with plastic, insulating sleeves. Sounds like you need to check them out and make sure they're clean, making a good contact and not shorting across each other due to perished insulation. Do one cable at a time so you don't get them mixed up!
 
hubbs44 said:
where are the earthing points?
Click to expand...

It probably isn’t an earth issue, as the indicators are working, but opposite. The easiest fix is just swap the wires inside the trailer connector, but that doesn’t answer the question of why did it work before, but not now?
 
hubbs44 said:
where are the earthing points?
Click to expand...
The indicators are earthed via black wires in that bundle of wires I was talking about. It would be good to check they are all cleaned and electrically sound first. If the problem remains you could swap the two indicator feeds, as mick 1986 suggests, and see what happens.
 
You must log in or register to reply here.

Similar threads

robbie the greatl
trailer light socket
Replies
8
Views
994
robbie the greatl
robbie the greatl
T
Hazard/Trailer light
Replies
6
Views
994
miktdish
miktdish
C
Warning Light for WIPAC indicator module not lighting up.
Replies
1
Views
446
miktdish
miktdish
V
2007 tdc Trailer light socket brake light problems
Replies
5
Views
910
vtwin
V
ar1g3
P38A Bulb Failure message preconditions?
Replies
6
Views
607
Datatek
Datatek