Hi
I’m pretty new to the world of Nanocom and have recently purchased one to have a go at remapping my Defender 110 TD5 10p. I have used a company who write the map and send it across for me to load on using the Nanocom. Prior to doing the remap I sent them a log of the live data, which was said to be fine and I have gone ahead with the remap sending them another couple of logs of the live data. They have now told me that the map side of things is fine but have noticed high balance figures on cylinders 3 & 4. I questioned them asking if they’re were the same on the pre remap log to which they replied yes, a bit annoying!
I have been reviewing the balance figures and struggling to interpret exactly what they mean, If anyone has any advice on this it would be much appreciated. I have attached a copy of the logs to this post
Many thanks
Rob
I’m pretty new to the world of Nanocom and have recently purchased one to have a go at remapping my Defender 110 TD5 10p. I have used a company who write the map and send it across for me to load on using the Nanocom. Prior to doing the remap I sent them a log of the live data, which was said to be fine and I have gone ahead with the remap sending them another couple of logs of the live data. They have now told me that the map side of things is fine but have noticed high balance figures on cylinders 3 & 4. I questioned them asking if they’re were the same on the pre remap log to which they replied yes, a bit annoying!
I have been reviewing the balance figures and struggling to interpret exactly what they mean, If anyone has any advice on this it would be much appreciated. I have attached a copy of the logs to this post
Many thanks
Rob