S

steve7168

Member

• May 29, 2015

• #1

Tomorrow I'm fitting my synergy box, it seems quite straight forward.
My question is, how do I set the settings in Range A + B?
I have a little black thing to adjust the settings, but do I have the air + fuel switches set to off and then adjust?
Thanks in advance

 

K

kourgath

Member

• May 29, 2015

• #2

The instructions you get with it are pretty good, I fitted mine OK.

If you are not changing the MAF from Bosch to Pieburg then use 1-5.

I found fitting the Ronbox pretty simple, getting the air filter housing back on a bit annoying (but then I had practice from a Rover 75 with the same engine). The in cab switch though was a complete PITA which even left me having to go to the physio to straighten out my back...

 

S

steve7168

Member

• May 30, 2015

• #3

yes but how do I set it between 1 - 5??

 

K

kourgath

Member

• May 31, 2015

• #4

There should be a small grey stub near the 2 switches. Maybe yours has fallen out I seem to remember something about that in the instructions. You just turn that from 9 o'clock (1) to let say 11 o'clock (3) etc

 

S

steve7168

Member

• Jun 1, 2015

• #5

Thanks for that, do I switch the air and the fuel switches to off then adjust the settings?
That's the part I'm confused about. There is nothing in the instructions on how to do it.

 

K

kourgath

Member

• Jun 1, 2015

• #6

I've changed both switches to on and chosen my tune then run the engine - i.e. made the changes with the ignition etc off.

The cab switch allows the system to be in 3 states - ECO1, ECO2 and whatever you chose on the ronbox in the engine bay. To enable your choice all you have to do is lift off the accelerator pedal.