M

mfp2gosling1

New Member

• Mar 3, 2013

• #1

So havng bought a Synergy 2 with a dash switch I'm not sure where the best place is to fit it so where about have you guys fitted yours?

Pictures would be good

 

R

rhodie

Active Member

• Mar 3, 2013

• #2

mines right hand side of steering wheel passed lead through bonnet release cable hole.
attached with velcro

 

M

mfp2gosling1

New Member

• Mar 13, 2013

• #3

I had a look at this today Rhodie, you must have either tiny hands or be double jointed, I struggled with it for a while then gave up for the day, might try again tomorrow if the weather holds.

Did you put ot through with the cable or down the side between the rubber and bulkhead?

 

R

rhodie

Active Member

• Mar 13, 2013

• #4

mfp2gosling1 said:

I had a look at this today Rhodie, you must have either tiny hands or be double jointed, I struggled with it for a while then gave up for the day, might try again tomorrow if the weather holds.

Did you put ot through with the cable or down the side between the rubber and bulkhead?

Click to expand...

Just remove water tank to one side and use a wire coat hanger

 

Singvogel

Well-Known Member

• Mar 13, 2013

• #5

I've got an auto - so used the redundant rubber bung hole for where the clutch pedal would be.

 

F

frontosa

Active Member

• Mar 13, 2013

• #6

fitted mine right hand side of steering wheel next to cruse control switch.
will rtake a pic tomorrow