smckeown73

Active Member

• Aug 28, 2013

• #1

Hi all,
Just about to but an entire set of front shocks, springs, turrets and rings in. Here are the items provided by procomp. Am I missing a set of washers to cup each rubber washer ?

Top:

Bottom

It was the same story with the rears also.

Cheers
Sean

 

Jamespepperpot

New Member

• Aug 28, 2013

• #2

The washers that cup the bushes look like they are on there? On the rear ones the middle washers are welded/rusted on to the bracket normally

 

Boris113

Well-Known Member

• Aug 29, 2013

• #3

Are those the Gwyn Lewis turrets?

If so then the top of the shock should have another washer either side of the turret, seperating the bush and preventing the shock pin moving side to side in the turret.

It will look slightly different to the ones you currently have, in that it has a lip that fills the gap between the shaft of the shock and the inner face of the hole in the turret.

I think this is the one:

NRC6235 CUP WASHER | shop | www.lrseries.com | L. R. Series

And this link should show the difference between the washers and your current ones.

8 x Long Travel Shocks + 5 inch Pin / Pin Shock Absorber Bush Isolation Washers | eBay

 

smckeown73

Active Member

• Aug 29, 2013

• #4

cheers Boris, very helpful

 

smckeown73

Active Member

• Aug 30, 2013

• #5

I have made do for now, but i'm very concerned with the clearance here.

Sean