smckeown73

Active Member
Hi all,
Just about to but an entire set of front shocks, springs, turrets and rings in. Here are the items provided by procomp. Am I missing a set of washers to cup each rubber washer ?

Top:
top.JPG


Bottom
bottom.JPG


It was the same story with the rears also.

Cheers
Sean
 
The washers that cup the bushes look like they are on there? On the rear ones the middle washers are welded/rusted on to the bracket normally
 
Are those the Gwyn Lewis turrets?

If so then the top of the shock should have another washer either side of the turret, seperating the bush and preventing the shock pin moving side to side in the turret.

It will look slightly different to the ones you currently have, in that it has a lip that fills the gap between the shaft of the shock and the inner face of the hole in the turret.

I think this is the one:

NRC6235 CUP WASHER | shop | www.lrseries.com | L. R. Series

And this link should show the difference between the washers and your current ones.

8 x Long Travel Shocks + 5 inch Pin / Pin Shock Absorber Bush Isolation Washers | eBay
 

Similar threads