taylorslandy72

Active Member

• Dec 27, 2014

• #1

Just to clarify a few things, starter wasn't throwing out when fitted, taken out and attached leads to battery and all seems to be fine, when it's fitted all I get is a wining noise and and no sign of engaging to flywheel. So frustrating

 

I

Ian46

Active Member

• Dec 28, 2014

• #2

Maybe you have teeth missing from the fly wheel.

 

samc88

Drivels spiritual representative

• Dec 28, 2014

• #3

Try pushing the land rover in gear a short distance and try again. If it starts then, you probably have teeth missing as said above

 

taylorslandy72

Active Member

• Dec 28, 2014

• #4

samc88 said:

Try pushing the land rover in gear a short distance and try again. If it starts then, you probably have teeth missing as said above

Click to expand...

Morning, starter taken off this morning all flywheel teeth seems to be fine, I tested starter on the floor and it's throwing out as it should, I am a bit stuck on how to get it spinning once on the floor ie what terminals to touch

 

samc88

Drivels spiritual representative

• Dec 28, 2014

• #5

http://www.landyzone.co.uk/lz/f6/testing-diesel-starter-motor-272787.html

 

jockmurray

Active Member

• Dec 28, 2014

• #6

if its a non pre engaged starter make sure the start dog is moving up the bendix when energised they can stick due to a build up of crap good clean with brake cleaner normally sorts it

 

taylorslandy72

Active Member

• Dec 28, 2014

• #7

jockmurray said:

if its a non pre engaged starter make sure the start dog is moving up the bendix when energised they can stick due to a build up of crap good clean with brake cleaner normally sorts it

Click to expand...

Yeh all sliding up and down as it should be, just when not fitted back on landy

 

zzr1200

Well-Known Member

• Dec 28, 2014

• #8

Try attaching a jump lead from the engine to the -ve battery terminal then try again its possibly a bad engine earth...and/or short the starter solenoid that could also be U/S...

hth