M

martinbennett

New Member
Hi
Does anyone know what to do if you have a siezed brake drum screw and you can't undo it? The head is completely knackered. I have tried pluss gas and alot of other rust releasing agents, a drill, impact driver and of course since the screw is totaly flat I cannot use pliers on it.
Any other suggestions before any more damage is done to my fingers?
Martin
 
drill and a 6mm bit.. yer dint need em cos the wheel nuts will hold yer drums on
 
I've been upto long, thought he was on about the adjusting snail:(

What slob says, ignore my post its bollox:)
 
you would be suprised i had to remove the front disks on a lexus ls400 and the customer had mullered the heads but once i got in there wiff me tappin hammer and a dotpunch they came out
 
lexus discs........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................... fooking miles..............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................series landrover drums
 
woz dat fing called that has a left hand thread and ya drill a hole and screw it in and as ya tighten it up it loosens the fing wots stuck?? that shud work
 
Screw extractors
But there is a problem with them if you snap them caus they are as hard as a hard thing. and they will be almost impossible to drill out then.
 
ffs all yer have to do it drill the center out the head, the rest of the head falls orf and yer can remove the drum. course cos the drum is stuck yer gonna have to back off the adjusters and **** it wiff yer big hammer.

stud extracters as yer maun says are hard, but brittle, so unlike a bolt you get no warning that its gonna snap so now you have to drill out a very hard thing with yer cordless black and docker.

as yer gonna have to drill anyways if you was gonna use a stud extracter then wtf dint yer just drill the head of the **** and be done wiff it?
 
do you ever think about going off into the bush for a few days with only 1/2 ltr of water? if not, then now might be a good time to try it
 
we always go off into the bush with no water. who the ferk needs ta carry water wen u can drink beer. :D
 
You must log in or register to reply here.

Similar threads

AJofShabby
1986 90 - transmission brake
2
Replies
30
Views
3K
AJofShabby
AJofShabby
D
Disco 2 M+S Light flashing and D flashing on display P0743 solenoid valve lockup clutch monitor (s/c to grou
Replies
1
Views
2K
Stanleysteamer
Stanleysteamer
Karlos the jackal
just for a laugh
Replies
4
Views
909
Mark Piercy
Mark Piercy
ukadamwest
P38A Tools Explained for P38 Owners
Replies
12
Views
1K
Bix
Bix
C
brake drum sourcing
Replies
3
Views
1K
Land Raver
Land Raver