Not got a clue when it comes to engines, I think that sounds good, here is mine I think mine sounds good too, this was when I was trying to sort front pulley out, think ive sorted it now.
 
border said:
Not got a clue when it comes to engines, I think that sounds good, here is mine I think mine sounds good too, this was when I was trying to sort front pulley out, think ive sorted it now.
Click to expand...

Presume that's cold.. sounds nice and quiet

Can't wait to get mine running again!!!
 
Sounds a bit tappety but nothing serious. Mine does the same - if you run it for few seconds and then stop then restart mine goes away suggesting oil pump either gunged up or worn. As I do so few miles in it I’ll leave it until it’s warmer to drop the sump. Try checking tappet clearances first
 
Agree with kermit in both cases, my 21/4 petrol was very quite at tick over with most of the noise from carb throat.
 
Try running it without oil. They ain’t used to being covered with orible slippy stuff inside. Much better with a few pints on the floor underneath.
:D
 
You must log in or register to reply here.

Similar threads

H
Swap grill and headlights from 2A to 3
Replies
4
Views
791
Tony Monsantoe
Tony Monsantoe
Gun7354
Landrover series 2a engine
Replies
2
Views
421
Gun7354
Gun7354
O
Series 3 buying advice
Replies
16
Views
1K
Bobsticle
Bobsticle
O
Series 3 Drum to Disc conversion on a series 3
Replies
3
Views
254
Anaconda
A
O
series 3 - conversion from drum to disc brakes
Replies
11
Views
654
109SeriesIIA
1