S

Stacey007

New Member

• May 29, 2024

• #1

Hello

Possible project I'm looking at, but could do with knowing if a series 3 gearbox will fit in a series 1 without drilling any extra mounts to chassis etc.

Thanks

 

tottot

Well-Known Member

• May 29, 2024

• #2

What wheelbase?

 

H

Hicap phill

Well-Known Member

• May 29, 2024

• #3

Also what engine?

 

S

Stacey007

New Member

• May 29, 2024

• #4

Hello

It's a 86" series 1 and would like to know if a series 3 gear box would mount with no additional brackets / welds to the chassis etc


Thanks

 

H

Hicap phill

Well-Known Member

• May 30, 2024

• #5

Stacey007 said:

Hello

It's a 86" series 1 and would like to know if a series 3 gear box would mount with no additional brackets / welds to the chassis etc


Thanks

Click to expand...

You will have to make/cut part of the bulkhead to allow the slave cylinder on the gearbox.

What engine are you using?

 

Rangieman123

Member

• May 30, 2024

• #6

From memory, your 86'' has a solid shaft clutch release mechanism from the pedal. So no hydraulic clutch.
You would need to keep your original bellhousing but I don't know for sure if it will correctly fit to a Series 3 gearbox.

 

Rangieman123

Member

• May 30, 2024

• #7

or you could convert to hydraulic clutch.

 

tottot

Well-Known Member

• May 30, 2024

• #8

OR it is possible to fit a series 3 box with the bell housing/clutch unit from a 2/2a box

 

H

Hicap phill

Well-Known Member

• May 30, 2024

• #9

Rangieman123 said:

or you could convert to hydraulic clutch.

Click to expand...

Yep that’s what I done.on 80”pedals through the floor
Now where do the pedals come from on the 86…. Through the floor or top of the footwell?