S

ssdisco

Member

• Jul 28, 2012

• #1

Hi there everyone im sorry to be a pain but ive just got a good 2.5na diesel engine to put back in my landy,ive swapped clutch engine mounts etc but just couldnt get engine to mate up with gearbox any suggestions tips would be much appreciated cheers steve

 

jamesmartin

Well-Known Member

• Jul 28, 2012

• #2

have you checked theres no dowels or excess studs series boc bellhousing is a tight fit and does need gear box hold up firmly and engine pushing up square to it ,removing engine mounts helps

 

S

ssdisco

Member

• Jul 28, 2012

• #3

Thanks for the quick reply mate ive removed rubber engine mounts to get engine a bit lower,had gearbox wedged up but when trying to push engine towards box it kept dropping hope this was my problem cheers.

 

crashbox

Well-Known Member

• Jul 28, 2012

• #4

Have you centred the clutch with the gearbox shaft?

 

Sirus

Your all Banned except me

• Jul 28, 2012

• #5

Just keep trying... Jack the box up, Mess about with levelling the engine. Then when your really ****ed off it usually just drops straight in and laughs at you.

 

S

ssdisco

Member

• Jul 28, 2012

• #6

Hi there i dont have a clutch aligning tool so i just centred the best i could,looks to be in the centre.Hope this will be ok.

 

crashbox

Well-Known Member

• Jul 28, 2012

• #7

ssdisco said:

Hi there i dont have a clutch aligning tool so i just centred the best i could,looks to be in the centre.Hope this will be ok.

Click to expand...

You will mess about all day if it aint centred. It only has to be a baw hair out, also try turning the engine/gearbox slightly as the splines have to match up as well.

 

F

Ferret123

Member

• Jul 28, 2012

• #8

Another possibility is that youve got an imperial gearbox bellhousing and the 2.5 N/A will be metric which the treads are a tiny bit too big my bellhousing had to be drilled for a 110 2.25 petrol, let us know how you get on

 

samc88

Drivels spiritual representative

• Jul 28, 2012

• #9

We just use an old half-shaft as an alignment tool.

 

M

mikebeetle

New Member

• Jul 29, 2012

• #10

Helped someone from this forum who had the same problem yesterday (albeit a 200tdi). The clutch plate was out of line so we sorted that with an alignment tool i had made up a few years ago.
The wading plug on the flywheel housing was also catching on the gearbox crossmember so just jacked the 'box up a bit. Check for that too.
After that it went in ok

 

S

ssdisco

Member

• Jul 29, 2012

• #11

cheers for the help guys as for the studs being too big i havent even got that close yet i will keep you all informed,i have a mate coming this morning to give me a hand easier with two people.

 

Vagrent

Yaaaar

• Jul 29, 2012

• #12

Have you tried opening the bonnet?:lol:

 

S

ssdisco

Member

• Jul 30, 2012

• #13

Hi guys thanks for all the help ive managed to get engine in and running just need to pipe it all up now and thanks to this forum ive even got a good clutch pedal now (i didnt know they could be adjusted)thankyou all very much.