harris hawker
New Member
Ok i need some advice before the grinder comes out
After having a good look over my series 2a i have found some good bodge jobs have been done on both of the doors, passenger side has been bolted all the way though into the footwell and the top of the pillar is goosed, the drivers side the bottom hinge has been welded in place due to a crap plate welded to the pillar and the top is not much better, so i have ordered two bulk head repair corners and door pillars.
Now am i right in thinking that when i do the bulk head corners i will cut ot the bad and trim the new to fit in flush and then weld them up and gind it smooth???
but i have no idea where to start with the pillars? so could do with some much need advice please
After having a good look over my series 2a i have found some good bodge jobs have been done on both of the doors, passenger side has been bolted all the way though into the footwell and the top of the pillar is goosed, the drivers side the bottom hinge has been welded in place due to a crap plate welded to the pillar and the top is not much better, so i have ordered two bulk head repair corners and door pillars.
Now am i right in thinking that when i do the bulk head corners i will cut ot the bad and trim the new to fit in flush and then weld them up and gind it smooth???
but i have no idea where to start with the pillars? so could do with some much need advice please