This may be a little crazy, but here goes.
I have acquired a 110 county TD5 Cat C that was written off due to an interior fire. There's not that much damage, drivers seat, roof lining, driver's door and b-pillar plastic and a very messy damaged dash where the perpetrators clearly tried to start it, got fed up, ripped out the centre console containing the radio and fled. It still starts and drives and is in excellent condition otherwise.
So I need to scrap the chassis to comply with the cat C along with the interior due to smoke damage/toxic chemical contamination.
I understand that anything I do with it will now probably (definitely?) result in a Q plate, which doesn't bother me in the slightest.
I would love to buy a new 90 galv-chassis and reuse most of the 110 to create a soft top 90 (SVX style). Mechanically and body-work wise the 110 is in excellent condition so what bits would I need in addition to what can be re-used from the 110?
We'll start with the rear tub, fuel tank and rear prop-shaft. So apart from the obvious soft-top components, can anyone point me to a list of other stuff I'll need?
Also, is there a recommended guide for a chassis swap? I have a barn in which to carry out the conversion and am reasonably competent (I already have a 110 TD5 County daily driver that i do all the work on).
All help is appreciated.
Cheers.
Rich.
I have acquired a 110 county TD5 Cat C that was written off due to an interior fire. There's not that much damage, drivers seat, roof lining, driver's door and b-pillar plastic and a very messy damaged dash where the perpetrators clearly tried to start it, got fed up, ripped out the centre console containing the radio and fled. It still starts and drives and is in excellent condition otherwise.
So I need to scrap the chassis to comply with the cat C along with the interior due to smoke damage/toxic chemical contamination.
I understand that anything I do with it will now probably (definitely?) result in a Q plate, which doesn't bother me in the slightest.
I would love to buy a new 90 galv-chassis and reuse most of the 110 to create a soft top 90 (SVX style). Mechanically and body-work wise the 110 is in excellent condition so what bits would I need in addition to what can be re-used from the 110?
We'll start with the rear tub, fuel tank and rear prop-shaft. So apart from the obvious soft-top components, can anyone point me to a list of other stuff I'll need?
Also, is there a recommended guide for a chassis swap? I have a barn in which to carry out the conversion and am reasonably competent (I already have a 110 TD5 County daily driver that i do all the work on).
All help is appreciated.
Cheers.
Rich.