Qasimahmed
Member
Hello again.
I took apart the wiper motor today to change the plastic gear as it would stop midway and needed a little nudge to continue. Changed the gear and the wiper did not work. So I put a constant 12v onto the wiper and it started working, the problem is that it doesn't return to the rest position after completing the cycle and stops anywhere.
The second issue is the rear washer. When I put 12v to the washer pump, the water squirts about perfectly, but when pushing the stalk back, absolutely nothing from the washer pump.
Any ideas?
Thanks a lot
I took apart the wiper motor today to change the plastic gear as it would stop midway and needed a little nudge to continue. Changed the gear and the wiper did not work. So I put a constant 12v onto the wiper and it started working, the problem is that it doesn't return to the rest position after completing the cycle and stops anywhere.
The second issue is the rear washer. When I put 12v to the washer pump, the water squirts about perfectly, but when pushing the stalk back, absolutely nothing from the washer pump.
Any ideas?
Thanks a lot
Last edited:
