steve2286w
Well-Known Member
Yes think so , I took mine off but this might help
www.landyzone.co.uk
Series swb rear tub
Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is Iβm replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...
www.landyzone.co.uk
Gun7354
Well-Known Member
Thanks SteveYes think so , I took mine off but this might help
Series swb rear tub
Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is Iβm replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...
steve2286w
Well-Known Member
Also the easy option to remove bolts at rear to jack up 15mm to give clearance to get the steel supports out
steve2286w
Well-Known Member
Mine rotted through where the steel supports touched the floor (electrolytic corrosion) so paint it well of use some thin insulation between them
yrmit.co.uk
Land Rover Defender 90 & Series SWB Rear Tub Floor Assembly - YRM Metal Solutions
Parts used 3no. 061 Land Rover Defender 90/110/130 & Series SWB/LWB Underfloor Support Strutt 3no. 087 Land Rover Defender 90/Series SWB Rear Floor Support Top Hat 1no. 091 Land Rover Defender & Series 2 & 3 Rear Door Thresh 1no. 092 Land Rover Defender & Series 2 & 3 Rear Door Rubber Seal 1no...
yrmit.co.uk
