Gun7354

Well-Known Member

• Feb 22, 2024

• #1

Hello knowledgeable folk.

Can I remove my rear floor (SWB) and replace the supports (and top hats) with the tub on?

Noticed that a few have holes in…….

Thanks

Rich

 

steve2286w

Well-Known Member

• Feb 23, 2024

• #2

Yes think so , I took mine off but this might help

Series swb rear tub

Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...

www.landyzone.co.uk

 

Gun7354

Well-Known Member

• Feb 25, 2024

• #3

steve2286w said:

Yes think so , I took mine off but this might help

Series swb rear tub

Going to try rebuilding the swb series 3 tub soon Got ali for floor and decent top hat and crossmembers Picked up rear quarters panels new and capping etc is good Problem is I’m replacing driver side rear wing. Picked one up with b pillar on it, so that should help But not sure on the spot weld...

www.landyzone.co.uk

Click to expand...

Thanks Steve

 

steve2286w

Well-Known Member

• Feb 26, 2024

• #4

Also the easy option to remove bolts at rear to jack up 15mm to give clearance to get the steel supports out

 

Gun7354

Well-Known Member

• Feb 26, 2024

• #5

Thanks mate

 

steve2286w

Well-Known Member

• Feb 26, 2024

• #6

Mine rotted through where the steel supports touched the floor (electrolytic corrosion) so paint it well of use some thin insulation between them

One moment, please...

 

Gun7354

Well-Known Member

• Feb 26, 2024

• #7

great link Steve, thanks