Riich said:

While at Paddocks the other day collecting some parts, there was some confusion about my drive flanges/half shafts on the back and I ended up buying 4 front type drive flanges. I went to fit the rears earlier to find I have one peice flange/shafts. Now that I have the extra set of flanges (I changed the fronts too) its not worth taking them back, so can I convert to a seperate shaft thats independant of the flange? I see they have rear shafts listed, but without the right knowledge I don't want to buy the wrong things again.

Click to expand...

jamesmartin said:

one pice shaft and flange is the best ,the flanges are for fronts or 110s

Click to expand...

bankz5152 said:

How come? My rear shafts (on the 110) where a little worn so I replaced them with the shaft/flange system.

Is the single unit that much better?

Click to expand...

bankz5152 said:

Ok i think I get you, so no point in swapping for the solid one peice shafts?

Click to expand...

bankz5152 said:

Hmmm be good to know... ill try and find out

Click to expand...

jamesmartin said:

once you get to 300tdi the drive members arent lubricated,splines are prone to rust and wear,110 flanges /shafts are commonly worn

Click to expand...

ogb said:

Agree. The problem has other facets, though. The rust can be fought with some oil in the shaft end cap. When the wear gets too much you can hear the clonk and, in my experience, it's the drive flange that gives up first -by a long way. This makes it easy to carry a spare flange to enable a roadside fix to the loss of drive. I fitted some HD flanges to my last 110 but I'm not sure that this was the right move - it shifts the point of failure somewhere else. Because of that I ended up carrying spare half-shafts on my last long trip in case the flanges did their job too well. I guess there's no Right Answer.

Click to expand...