Came to change a rear axle in a 200tdi (10 spline) discovery today the one i took out had thick half shafts and the new one had thinner halfshafts and about 4 inches from the flange bolts had a machined ring on the half shaft.
When i came to swap the discs over i thoight i could just swap the hub and bearing assembly but it seemed the stub axle is not long enough and i could not get both of the hub nuts on
Is it just a case of changing the stub axles aswell?
Cheers
When i came to swap the discs over i thoight i could just swap the hub and bearing assembly but it seemed the stub axle is not long enough and i could not get both of the hub nuts on
Is it just a case of changing the stub axles aswell?
Cheers