v8250
Well-Known Member
Just looked this up. Will give it a try. Has some quite basic ingredients https://www.innotec.eu/write/bestanden/veiligheidsbladen/21_DeblockOil_1203_en.pdf
meego
Well-Known Member
I don’t think you’ll be disappointed. You can actually watch it disappear into whatever you spray it on. I don’t think it’s cheap though.
v8250
Well-Known Member
£17.99 a 400ml can. I normally use PlusGas and then out with the MapGas if things get very stubborn. And for really stuck old pistons in cylinders it's out with the full fat Coca-Cola. Coca-Cola always works on truly stuck pistons. By far the most difficult to remove are the long head to block studs on Jaguar XK/XJ engines... they go all the way down into the water galleys and rust weld themselves to the iron block.
WhiskyLassie
Well-Known Member
meego
Well-Known Member
If you do try it, let me know your thoughts .
PB B'LASTER PENETRANT - B'laster Products
The #1-selling penetrant since 1957, PB B’laster quickly busts loose rusted or frozen parts caused by rust and corrosion. It also contains a non-evaporating lubricant that saves time and equipment and protects against further rust and corrosion. Features #1-Selling Penetrant Breaks Free Rusted...
blasterproducts.com
I’ve been using this stuff recently. Been great so far, no complaints.
Available on Slamazon - but again, it’s not cheap stuff.
1988smithy
Well-Known Member
meego
Well-Known Member
It’s quite hard to judge what stuff is the best from what’s on the market, as every seized fixing will probably be different from others. I tried this stuff on an old steel hinge I found that had been lying outside for ages and was totally rusted solid. It freed off in seconds after one spray. It also seems to dissolve surface rust !! Not totally dissolve of course, but enough to make it look almost usable again.
DevonGuy
Well-Known Member
I’ll be interested to see if it helps me with dissimilar metals corrosion. My main holdup in the workshop.
meego
Well-Known Member
If it’s to let it creep in between these metals why not try ATF/Acetone mix ?? The acetone evaporates out and leave the ATF, so that might work.
DevonGuy
Well-Known Member
Yes, that’s a good mix. Used to have a tank of all sorts once, all the solvents and oils used to get tipped in it. A few days and anything would come free.
I’ve ordered a can of this new gear and I’ll give it a go.
meego
Well-Known Member
Hope it works for you. Keep me posted
meego
Well-Known Member
That’s a good idea actually. I’m going to find something that fits under the bench and chuck some atf and kerosene and whatever else I can find in. Cheers
