Datatek
Well-Known Member
Window not working could be a number of things from broken wires between the door and A post to the window proped up with a bit of wood and the regulator missing. Most often it's the switch pack.Hi Data
Checked white plugs behind kick panel as you suggested. The two white multi plugs look good. I left the panel off just incase I can do a test from there later. I read a thread somewhere advising to solder all the wires behind passenger side kick panel and drivers side straight through ( as this is where eas ecu cables run) and shrink some wire shrink tubing over it. Would that help? Still cant get a handle on the passenger widow issue though.
A few drops of water were on the carpet beside the kick panel. Had a think then removed the
Pollen filters from front scuttle. The sorbo rubber seals were dislodged and the filters had never been changed from new I dont think. I sorted the damaged sorbo seals and have ordered new pollen filters. The drops of water had bypassed the seals on pollen fltter and run down body frame inside. Learened more stuff today.
Car sitting only 5mm down on FR now, gonna try and recalibrate it tomoz. Ride height switch still ****ing about. I had access light on only while on Std. Then I had High and Roadlights on next. I press the switch and it reacts some time others not. Frustrating or what!! Under what conditions will the ride height switch function properly again Data.
Cheers again
Slingo
Corrosion in the connectors can be hard to see, soldering and heat shrinking is a good idea if you can solder.
Ride height switch will function correctly when you find the fault. Could be the switch itself but more likely connectors.