If you had given him the part number you first quoted and your car is after Vin WA409249 roughly around 98 on, it would have been the right one. Before that Vin STC2296.
Last edited:
If you had given him the part number you first quoted and your car is after Vin WA409249 roughly around 98 on, it would have been the right one. Before that Vin STC2296.
Jake Hewitt
Active Member
Is it not possible to just buy the elbow?
If so, does anyone know what this part number might be?
Holy crap, Jake. It is over 5 years since the last post on this thread!
Jake Hewitt
Active Member
I know, but I just broke mine, and Google brought this thread up!
Jake Hewitt
Active Member
I could say it disintegrated too, but I won't lie, I forced it and it snapped. It's how I learn
Datatek
Well-Known Member
You sure that a Fiesta filter will give enough fuel flow for a bigger thirstier engine?
Yep, similar size filter and pipes and same bore. Runs just fine
Jake Hewitt
Active Member
The entire fuel filter holder housing?
Removed the header that the filter screws into and used some fuel pipe and clamps to fit new filter. You can use a large jubilee clip to hold filter to bracket.
It was something like this one
https://www.eurocarparts.com/ecp/c/...8ecd0aaab51a400db5314c82ab0f720e9c96c3&000140
https://www.eurocarparts.com/ecp/c/...8ecd0aaab51a400db5314c82ab0f720e9c96c3&000140
Jake Hewitt
Active Member
I've ordered some bits now anyway, but thanks
Chrispndry
Member
Where did you get the elbows from....I've ordered some bits now anyway, but thanks
Chrispndry
Member
Where did you get the elbows from
He's not been on since Feb 2021 matey, you may not get and answer to that one
RangeRoller dt
Well-Sprung Member
Was nice to remember @TAKdriver though.
