About to change the oil seal on the drive shaft port side front. According to RAVE, the ABS sensor must be removed, but of course the sensor is as welded to the hole.
Question is: is it possible to pull the drive shaft without removing the ABS sensor or is this physical impossible?
New sensors are in the post a week away so if I can do the job without pulling the sensor, would be great.
Thanks for opinions.
L
Question is: is it possible to pull the drive shaft without removing the ABS sensor or is this physical impossible?
New sensors are in the post a week away so if I can do the job without pulling the sensor, would be great.
Thanks for opinions.
L