ChrisRoverTurbo
New Member
I just recently purchased my 2013 Land Rover LR2 HSE and already got a check engine light after 2 weeks of having the car may I please get some insight and the severity of this code.
All faults are fixable.
Why is it throwing that code?
Why have you posted this here and not in the Range Rover Section where it will be seen by LR2 experts?
its over here: https://www.landyzone.co.uk/forum/range-rover.10/
Why is it throwing that code?
Why have you posted this here and not in the Range Rover Section where it will be seen by LR2 experts?
its over here: https://www.landyzone.co.uk/forum/range-rover.10/
ChrisRoverTurbo
New Member
Thank you for your help I’m new to this page
Dan, the LR2 is the US name for the Freelander 2….
OOPs!
There could be a lot of reasons as to why you would get this type of code. You will have to pinpoint the cause of it.
appleje197
New Member
he engine light was on and i was getting shifting problems. So i decided to take to the dealership.
CODE PO7A300 TRANSMISSION FRICTURE AT CLUTCH A STUCK ON CODE P2787 CLUTCH A TEMP TOO HIGH CODE 2872 CLUTCH A ENGAGED YOU ALSO HAVE A CLUTCH B MOTOR THEY NEED TO SWAP CLUTCH A MOTOR WITH CLUTCH B MOTOR TO SEE IF YOU NEED BOTH MOTORS OR JUST ONE.
https://www.routerlogin.net/
pikashow
CODE PO7A300 TRANSMISSION FRICTURE AT CLUTCH A STUCK ON CODE P2787 CLUTCH A TEMP TOO HIGH CODE 2872 CLUTCH A ENGAGED YOU ALSO HAVE A CLUTCH B MOTOR THEY NEED TO SWAP CLUTCH A MOTOR WITH CLUTCH B MOTOR TO SEE IF YOU NEED BOTH MOTORS OR JUST ONE.
https://www.routerlogin.net/
pikashow
Last edited:
Stop shouting ...
And in the wrong section too...
