Shimsteriom
Master Procrastinator
You might want to remove the postcode from your profile
Just use something more generic
blue beasty
Leaks an prone to bits dropping off
You might want to remove the postcode from your profile
Edited
brianconwy
Well-Known Member
We took the cross member off and the rear steering bar and dropped the front end of the propshaft.
On the bottom? Nothing. Differences are in the head. Fuel return from above the alternator back behind the air intake. Timing chain tensioner. Green injectors on late engine. Cam part number - not sure exactly what the differences are between them though. Valve cover gasket.
Alistair Davidson
Member
Doing full rebuild so timing chain and head removed.
Was checking oil pump condition last week and and in doing so removed whole oil pump/stiffener plate assembly...along with pump sprocket and chain.
Manual said to make pen mark on inner rotor against outer rotor prior to removing inner rotor so to be able to replace after inspection the same way.
If i forgot to do the pen mark...is that a problem?
Dont understand the need for the mark as the rotors rotate separately anyway (as in the lobes of the inner cogs change which section of the outer rotor they mesh with every rotation.....?)
Thanks in advance
Was checking oil pump condition last week and and in doing so removed whole oil pump/stiffener plate assembly...along with pump sprocket and chain.
Manual said to make pen mark on inner rotor against outer rotor prior to removing inner rotor so to be able to replace after inspection the same way.
If i forgot to do the pen mark...is that a problem?
Dont understand the need for the mark as the rotors rotate separately anyway (as in the lobes of the inner cogs change which section of the outer rotor they mesh with every rotation.....?)
Thanks in advance
Alistair Davidson
Member
How about stiffener plate bolts? Replace those with new ones like manual says or ok to reuse existing ones...?
