guineafowl21
Well-Known Member
Are you sure it’s not just blowing out the dipstick? Have a look with engine running - pull dipstick (watch out!) and see if oil sprays. See if undoing the oil filler improves it.
If so - blocked crankcase breather filter.
If so - blocked crankcase breather filter.
Arctic2
Well-Known Member
I agree with the above looks to be coming from dip stick tube, also I note your small belt as quite a few cracks in it, I would be changing that before it snaps, link below for the right belt
http://www.ebay.co.uk/itm/Fan-Drive...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649
http://www.ebay.co.uk/itm/Fan-Drive...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649
guineafowl21
Well-Known Member
Ah, in that case, it’s not going to be easy to help you remotely. Have the engine running and look long and hard with a torch. Consider a UV leak detection dye. Are you sure it’s engine oil? What about PS pump? HP fuel pump?
Shaun4456
Active Member
Starting to think this is some thing else
Cleaned sump gasket and engine again
Took for run no leaks like yesterday
But I started it this morning and turned car round as needed put skid plate on.
Went under and seen drips and gasket soaked etc.
Could fuel pump pee out fuel on first start. I can't smell so can't work out if oil or could be diesel
But can't see no oil leaking. Been out for long drive. Checked see about 20 times and nothing
Cleaned sump gasket and engine again
Took for run no leaks like yesterday
But I started it this morning and turned car round as needed put skid plate on.
Went under and seen drips and gasket soaked etc.
Could fuel pump pee out fuel on first start. I can't smell so can't work out if oil or could be diesel
But can't see no oil leaking. Been out for long drive. Checked see about 20 times and nothing
guineafowl21
Well-Known Member
Leaking HP pump could be it - spray with brake cleaner, allow to dry, then start car and watch.
Shaun4456
Active Member
I cleaned engine.
Left it to dry took for long run and nothing
Will check it in morning before I start it.
If nothing will start and see if it leake.
teddywood1
Well-Known Member
mine was like that when the high pressure pump was leaking I think it is to clear to be engine oil
Shaun4456
Active Member
What did you have to do to fix fuel pump leak???
Shaun4456
Active Member
Think all have to put to some one who knows better than me on this one.
But still looking at info on how to remove and fit. Re doing the unit we new seals could be interesting lol
Shaun4456
Active Member
I not done one before. Seem on you tube how to do but not sure I no that much to do it
Shaun4456
Active Member
Is the tool to push pump threw of the guide.
Do you need to lock engine we bolt or something as not got locking tool
As could do this I think lol
Shaun4456
Active Member
Hi will Def need tool as going to order unit and fit next Sunday Shaun
Arctic2
Well-Known Member
This is the tool you will need below, to hold the sprocket also best to remove the manifold, and the starter motor, you may also have to raise the engine a little to clear the side of the chassis to insert the tool, you will need 17mm Allen key to remove the main cap for the tool to fit as well,
http://www.ebay.co.uk/itm/BMW-LANDR...Removal-Tool-Special-Short-Body-/190350761889
Shaun4456
Active Member
Is this pump any use ??? As bosh one that's in just now but wondered if this pump good or not. Thanks
