Mr Noisy said:
Proper keen that job!! :eek:

Maybe easier for the amateur builder to cut of and reweld the axle tubes?
Click to expand...

Well in theory yes, but you need something bit to press the tubes in and its easy to get the alignment wrong or warped after welding. Bit not impossible at all.
 
Drizz said:
Look back through here and youll see Mike redrilling them :)
Click to expand...

Sorry Drizz, I must have missed that one :D

I have seen people weld the axle tubes but that just goes against my mechanical comfort zone, too much stress relying on my welding lol
 
I was thinking you could sleeve inside the tube to help spread the load maybe and then weld all around.
 
Just finished reading from the start, made an awesome job of it so far boys!!


GreenHornet said:
Sorry Drizz, I must have missed that one :D

I have seen people weld the axle tubes but that just goes against my mechanical comfort zone, too much stress relying on my welding lol
Click to expand...

Get chopping mate and I'll be happy to glue it back together!
 
Drizz said:
The swivels were very tough to drill too. Took ages!
Click to expand...

Mill dan mill lol I decided to slot the swivels and drill and tap a extra hole for location rather than cut and weld the axle as I was a little concerned about the haz with welding and the axle fracturing around the weld but im sure with sleeving it would be fine.... I have made a jig for the swivels which makes it very accurate and easy to do but time consuming as some replacement swivels ive found to be very hard
 
It's just crimping the connectors on that's all. Just hinting to Mikey as he has the big crimping tool lol
 
mikeyt said:
Mill dan mill lol I decided to slot the swivels and drill and tap a extra hole for location rather than cut and weld the axle as I was a little concerned about the haz with welding and the axle fracturing around the weld but im sure with sleeving it would be fine.... I have made a jig for the swivels which makes it very accurate and easy to do but time consuming as some replacement swivels ive found to be very hard
Click to expand...

Slotting is a NICE idea, gives you infinite adjustment! :D

I have a habit of snapping swivel balls off, I really wish someone would make an HD/stainless steel version!!!

The Teflon ones seem to be made out of cast pig iron/cheese, were the original chrome ones any better metal?

Cheers :)
 
Mr Noisy said:
Slotting is a NICE idea, gives you infinite adjustment! :D

I have a habit of snapping swivel balls off, I really wish someone would make an HD/stainless steel version!!!

The Teflon ones seem to be made out of cast pig iron/cheese, were the original chrome ones any better metal?

Cheers :)
Click to expand...

Ive found the new teflon ones to be a very hard material that dosnt like to be machined and picks up, all older ones I have machined have seemed to be a lot more machinable. Which out of the two is a better material for the swivels i do not know
 
You must log in or register to reply here.

Similar threads

B
ABS Issue
Replies
14
Views
598
Bangerang1
B
G
ACE Roll bar too stiff for off road
Replies
8
Views
720
300bhp/ton
300bhp/ton
M
Disco 3 (LR3) Discovery 3 sagging overnight
Replies
0
Views
94
Matt BB
M
Andy Warren
Disco 2 Engine cover stripped threads
Replies
5
Views
578
Stanleysteamer
Stanleysteamer
F
Series 2 205/55/16 tyres on S2 1965?
Replies
8
Views
418
FinectiePhil
F