S

sashbash

New Member

• Jun 12, 2013

• #1

how big a job is it to change the output shaft on a lt77 box

 

Tom.JTC

Active Member

• Jun 12, 2013

• #2

I presume you want to do so because of worn splines? Output shaft is part of the mainshaft so requires a strip down of the gears, synchro hubs and bearings.

This might help. Rebuild of the LT77 Gearbox - Defender Forum - LR4x4 - The Land Rover Forum

 

S

sashbash

New Member

• Jun 12, 2013

• #3

thanks for that i will put up with the clonk a bit longer and save some pennys

 

flat

Well-Known Member

• Jun 12, 2013

• #4

have you taken it apart and looked at the state of the splines? Is it deffo the gearbox?

 

S

sashbash

New Member

• Jun 12, 2013

• #5

yes i have just put it in my landie the box has been modified to fit to a nissan motor the splines were well worn but i had to get it back on the road

 

flat

Well-Known Member

• Jun 13, 2013

• #6

It's going to be a strip and rebuild then, or modify a new unit, make sure you fit the cross drilled transfer box shaft and/or oil splash plate to prevent wear in the future