puddlejumper
Active Member
Remove 2 of the bolts holding the top on and fill with oil through one of them. The second one acts as a breather DO NOT REMOVE ALL FOUR BOLTS, doing this may lead to extensive NHS treatment. Relays are damned dangerous things if you don't know what you're doing 
Yup, me too. Ended up jacking the Landy up with the trolley jack foot on the bottom of the relay pin, and sledge hammering the chassis (wooden block sacrifices) to try to free it up. Mud and silt collect around the relay in the chassis former and set like concrete. There is a way to change the tufnol bushes in situ, but as Puddlejumper stated, get it wrong and several hundred pounds of angry spring pressure will try to remove your teeth (or the garage window in my case, long ago.....)
DarrenHS3
Active Member
method ! has to be said they take an age for the oil to drain down due to the tight fitting parts, so much so you will be fooled into thinking its nice and topped up when it isnt. i dont know the exact capacity but it took 9 of these syringes, so just under 100ml. which is like half a water cooler plastic cup, quite a bit ! jacking the front end up and going lock to lock sped up the settling of new oil inbetween syringes
mojofilter
Active Member
My steering relay was really stiff, to the point that the landy hardly self centred coming out of corners, I did mine over the course of days/weeks with dozens of shots from a 1ml syringe that came with my cats metacam, even with such a small dose, you would only get a few shots in before it overflowed and you had to leave it ages to permeate down.
cornish rattler
Well-Known Member
So I take it that a new one needs filling up before use, I always thought they was pre filled now I know why mine in the past was always stiff as there was never any oil in it.
I am fitting a new Bearmach one soon so I will arm myself with a syringe and some ep90 and fill it when I've fitted it
I am fitting a new Bearmach one soon so I will arm myself with a syringe and some ep90 and fill it when I've fitted it
mojofilter
Active Member
I thought they did come filled as new?
If I was filling one out before fitting it, I would probably try putting it in a vise and very carefully slackening all 4 top bolts to see if I could get a gap to pour oil in rather than the rigmarole of filling through the bolt hole.
If I was filling one out before fitting it, I would probably try putting it in a vise and very carefully slackening all 4 top bolts to see if I could get a gap to pour oil in rather than the rigmarole of filling through the bolt hole.
cornish rattler
Well-Known Member
Yep that's my thinking
kommer2013
Active Member
i just changed a steering relay over
Last edited:
kommer2013
Active Member
oh and also mine had oil already in
Last edited:
