jamesmartin
Well-Known Member
if its as it should be 11mm or 7/16 would be more usefulI had a very important part to play in today's work............ I got sent to halfords for two 10mm spanners
Shimsteriom
Master Procrastinator
Without which, the whole project would have stoppedI had a very important part to play in today's work............ I got sent to halfords for two 10mm spanners
Of the sixteen or so bolts holding in the radiator panel , some were 11mm, some were 7/16, some were 10mm and one was half inch -, and lots had different sizes on each end . The new imperial spanner set the kids got him for his birthday was only partially useful today . Think the term is that it was a right buggers muddleif its as it should be 11mm or 7/16 would be more useful
Shimsteriom
Master Procrastinator
That's British engineering for you
Lakes Rob
Active Member
And you made coffee - and roast chicken dinner!I had a very important part to play in today's work............ I got sent to halfords for two 10mm spanners
Lakes Rob
Active Member
And the battery was held in by a length of old seat belt!That's British engineering for you
Lakes Rob
Active Member
Did a bit more today. Got the floor and seat box out to reveal the gearbox. Two questions - shouldn't there a cover plate on the bellhousing, and what do these numbers mean on the end of the gearbox? There's no other serial number on there. Took the canvas off - very rotten, so that's going in the bin. Also, undecided whether or not to keep the roll cage!
jamesmartin
Well-Known Member
yes there should be ,512237 is its number
those numbers dont mean anything useful, number are either on rhs rear of box top or along the t/box top front edge
those numbers dont mean anything useful, number are either on rhs rear of box top or along the t/box top front edge
Lakes Rob
Active Member
Thanks James! I'll clean some more crap off tomorrow!
Lakes Rob
Active Member
Managed a few more jobs today. Near side wing off to see the state of the bulkhead. Thinking it might be better in the long run to just replace the whole bulkhead rather than repairing both sides! Engine out as well and removed all the wiring. The inside of the bell housing is fairly filthy! Tomorrow should see the gearbox out, offside wing off and the clutch / brake master cylinders and pipes out!
