I'll post photos of the Series 1 bits.honolulujoe
Well-Known Member
sounds ok
Mandy
Well-Known Member
My dad passed away in March and life has been pretty pear shaped until now! I've moved my mum over to Italy so I can look after her and it's only very recently that my life has taken on some sort of normality!
And so now I can finally start to dedicate some time to doing up my Series III. I've been thinking a lot about what I'd like to do with it and I've decided to start with a brand new chassis. I'm also considering opting for coil springs instead of leaf springs. Are there any chassis manufacturers who'll add coil spring mounts to a chassis before galvanising it? I'm not looking to create some sort of prototype or anything like that but I'm not convinced by leaf springs. Also, is it possible to get the vehicle's serial number stamped onto the chassis? Over here it's illegal to drive a vehicle without the serial number stamped on it!
And so now I can finally start to dedicate some time to doing up my Series III. I've been thinking a lot about what I'd like to do with it and I've decided to start with a brand new chassis. I'm also considering opting for coil springs instead of leaf springs. Are there any chassis manufacturers who'll add coil spring mounts to a chassis before galvanising it? I'm not looking to create some sort of prototype or anything like that but I'm not convinced by leaf springs. Also, is it possible to get the vehicle's serial number stamped onto the chassis? Over here it's illegal to drive a vehicle without the serial number stamped on it!
blue beasty
Leaks an prone to bits dropping off
Coils is a pretty big leap, have you considered parabolics?
Iirc both Richards and Marshalls no longer stamp chassis as it's a bit of a legal grey area. There's nothing to stop you stamping yourself though.
Does the original still have a visible number?
jamesmartin
Well-Known Member
these did, its a few years since i built a few so i dont know if they still do
https://www.google.co.uk/url?sa=t&r...co.uk/&usg=AFQjCNFHUfcBEcQYz-GcRxbAy-RpqXKr7g
blue beasty
Leaks an prone to bits dropping off
I was thinking maybe welding it on but it means breaking the galv protection.
As for springs I rate this guy's opinion http://www.glencoyne.co.uk/upgrade.htm
As for springs I rate this guy's opinion http://www.glencoyne.co.uk/upgrade.htm
jamesmartin
Well-Known Member
stamp the number yourself,as long as its a legit number etc ive made my own vin plates before for restored wrecks
jamesmartin
Well-Known Member
they are widely available from engineering factors etc and amazon it seems
https://www.google.co.uk/url?sa=t&r...LFYKQO&usg=AFQjCNEfBKh5esm7-rW8KEXpseB_8GicJw
blue beasty
Leaks an prone to bits dropping off
I agree, you won't get anyone official to recommend doing so but I can't see the problem, especially if you cut out and keep the original.
jamesmartin
Well-Known Member
you can have the front cross member moved forward during chassis rebuild a so use a std pas box or fit a p38 pas box to std series chassis,zeus do a disc conversion kit, ive fitted a few not too bad to do
https://www.google.co.uk/url?sa=t&r..._id=48&usg=AFQjCNEszeWZ4puUCIQXPumtlhvqkLTQdw
blue beasty
Leaks an prone to bits dropping off
11" twin leading brakes are pretty good when set up right, discs are probably a lot simpler once converted
