O

old guy

New Member
good evening people i have been scouring these forums for a couple of answers they are sort of explained but not quite if ya know what i mean .
i have done the "0" rings in the heater so disconnected the battery now work has been done all i get is a few bleeps ?? and nothing else no display ect .

other one is before i done this work all the suspension was working , but now it's limp on the o/s it's had new pump and bags , so my question is WHY ??
please help confused / p off had enough
:hurt:
 
nope battery was fine used pre heat turned over first time is there any way that the alarm needs to reset ??
 
yes it does start only the n/s rises to normal level o/s does not come up properly like it did before i disconnected the battery then i get a few bleeps like its trying to do something or reset its self
 
The EAS system doesn't bleep - if it faults out it will bleep at you and put a warning message on the dash display and the lights in the selection switch will all illuminate...

Are there any messages that accompany the bleeps??

IIRC, all bleeps that occur come with a message... i.e. Bleeps when a door is opened along with a message, bleeps to tell you the key is still in the ignition with message, lights still on with message, etc etc

Is it both O/S corners that don't rise?? or just one?
 
Did you take the dash out to do the "O" rings or the instrument binnacle? I would guess that you have disturbed a connector in the dash.
 
if the battery has been disconnected , the bleeps are likely to be the windows and sunroof not set
 
If the eas is sat down on the same side you should check the wheel sensor connections (maybe water got in there), won't be anything to do with battery disconnection.
You should get eas software and cable from datatek (send him a pm) so you can check everything yourself.
 
when old guy said he had no display , i took it as meaning the display was not working , of course it could mean just bleeps, and there was no messages on the display :confused:
 
tufty said:
when old guy said he had no display , i took it as meaning the display was not working , of course it could mean just bleeps, and there was no messages on the display :confused:
Click to expand...
A bleep is always accompnied with a message!!

As you say his display could be fecked....
 
hi guys merry Christmas and thanks for the help and advice , turns out that the windows and sun roof needed resetting , could not see the messages on the dash area because a couple of bulbs had blown what a plank :dnfnoob:
 
You must log in or register to reply here.

Similar threads

R
Missing infotainment system in Vogue 2010 TDV8 facelift version
3 4 5
Replies
96
Views
3K
roythebus
R
C
DEFENDER GOING IN TO LIMP MODE
Replies
8
Views
811
saxavordian
saxavordian
A
P38 2000 4.6 Thor vogue RHD HVAC issue
Replies
4
Views
273
alex230718
A
S
L322 02 Air Suspension inactive fault
Replies
6
Views
810
gold rover
gold rover
DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird