Looked like it was that 42nd floor place?
Yes, that's the one. I am cross-wires-matching it with the group "Level 42" obviously.
Well at least he did as he was told!!!Lad came with my new hydraulic hoses with the wrong ends.
Oblix is on the same level, but is not the same restaurantSo Oblix then, which kinda reminds me of the Asterix the Gaul books!
Well at least he did as he was told!!!
Well not really as he was given the old end to take with him.
D1Nut
Well-Known Member
Where's the christmas Grinch on here - surely there must be half a dozen or more people that would qualifyThink I should go n find the crimbo decorations, only got two lit up reindeers up atm (one inside one out)
Peeps have there houses glowing round here.
Leccy meters must be on overdrive.
WhiskyLassie
Well-Known Member
Grinch loves Xmas hates people.
WhiskyLassie
Well-Known Member
Morning all, early start shopping done fuel done and all ready to enjoy my bday weekend. Just gotta dig a dress and tights out to go somewhere fancy. 
Told Mr WL that he's driving so I can drink.
To the Clansman driver
Told Mr WL that he's driving so I can drink. To the Clansman driver
WhiskyLassie
Well-Known Member
While I was working on my Bonneville engine yesterday I noticed one of the camshaft bearings is shot. Its a phosphor bronze bush about an inch long and 7/8 inch bore, set into a blind hole. The tools needed to get it out (as per the workshop manual) are pricey, if you can find some, and doing the job "their"way can easily wreck the motor if it is not done with skill and care. So this morning I resorted to an old skool back street workshop method - cut some longitudinal slots in the bush with half a hacksaw blade (with the precision of a jeweller and care of a denterist), and collapsed the bush with some gentle prodding with a light hammer and screwdriver. Job done . New bush ordered and on the way -----.
. New bush ordered and on the way -----.
