i sent my key for repair bat went flat and now wont take EKA code it would only start before with EKA code before i sent remote i cant get remote to work as well side repeater flashes when i try to put code in dash comes up with its checks windows sunroof some of pickcels on dash is missing so cant see every thing on there some one said somthing about sill buton were is that am at a loss with it now got it moted and cant use it help please john
good bat on range rover new bat in remote
i opened door every time i put code in iv been told that stops it locking the becm up
how can you tell if becm is locked up thanks
Only if the microswitches are working.
iirc it says there's a timeout period if the EKA fails to go in after the 3rd attempt.
Where in the country are you and what engine / year is it? Someone nearby might have a Nanocom.
Datatek
Well-Known Member
What voltage do you have on the car battery?
atherton / m46ory when i unlock door with key it unlocks all the doors and tail gate thanks john
if i short the solanoed out it spins over but wont start cos imobilizer on
Datatek
Well-Known Member
The sequence of events is normally that when the BECM receives a valid FOB code, it repeatedly sends the mobilisation code to the engine ECU. If the FOB does not work, entry of the EKA code initiates the sending of the mobilisation code.
You really need a Nanocom to see what is going on.
Are there any messages on the dash like "Engine disabled"? Or "Enter EKA"?
If the BECM will not accept the EKA and the FOB doesn't work you have a problem.
I ask again, what is the battery voltage? Low battery volts will cause all sorts of problems.
uk and and atherton manchester thanks
Datatek
Well-Known Member
Look at the LZ Rescue map, there may be someone near you with a Nanocom.
i will try to fined my avo to see what volts are there cant get the fob to work it was operning with the key using the EKA code i used it got it moted the sent key away and bat went flat it has not run since thanks john
will do thanks
some of the pickcels are out on the dash so hard to see do all the windows have to be up and does it display that on the dash when you have door open and ignition on thanks
Datatek
Well-Known Member
To clear the "windows not set" messages, each window has to go fully down and then fully up with the ignition on. If there is a sunroof that also has to go through the setting procedure.
will try that tomorrow thanks
hi its 2.5 bm disel 1979 the key wont sync in does nothing new battery the key opens and shuts all doors thanks EKA code worked before main bat went flat now does not work
