R

rednecklandy

New Member
Looking for a wee bit of info on a 200 tdi gearbox with no reverse gear? when i say no reverse i mean that all gears work with not to many problems(slight crunching at times) exept reverse won't engage at all? knowlage of disco td5 and will do my best to answer any questions, knowlage of fabrication of all kinds. cheers
 
does lever go over to reverse or is it tight as there is a reverse plunger to enable 1st gear selection under tin top cover on disco or on drivers side under gearstick turret on defender,they can seize,if lever goes across but not in reverse switch can be wound into far ,or if lever goes across and into what should b e gear either gear worn or lever inside come adrift
 
Cheers pal. I had found that out this morning by a phone call but the reverse light switch was indeed too far in and just needed a slight adjustment. Many thanks
 
Hi James, with new clutch kit and thrust bearing on a reconditioned lt77 gearbox driven by a 1993 200tdi defender how do you adjust the pedal as it is right to the floor to work nearly? can it be done by bleeding? it works but crunches and just feels to low on the pedal? cheers
 
bleeding .and check reservoir for splashing ,means its on its way out and slave for leaks as its not oil it loses but ai it sucks in
 
The clutch release forks are known to wear through and give similar symptoms, was it checked for wear on the pivot point or replaced along with the clutch?
 
You must log in or register to reply here.

Similar threads

acidK1
Auto specialist advice
Replies
19
Views
692
pwood999
pwood999
Moorhouse2
Series 3 Gearshift Jammed in Neutral on S3
Replies
15
Views
1K
tottot
tottot
damian46
No reverse gear
Replies
3
Views
804
andyfreelandy
andyfreelandy
Lej
200 TDI cluch pedal randomly not engaging
Replies
16
Views
1K
steve2286w
steve2286w
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
8
Views
1K
miktdish
miktdish