Defenderdog1 said:
Done a proper job on that.
Click to expand...


Took 3 of us pretty much all day to get it into shape to fit my 90. It fits the rear window is secured and siliconed (poorly) in place, this was because I had to leave it overnight down Luton Town center and just covered it so they couldn't just open the rear door and get in. neater job req. The corners need re doing to get better but it passed scruteneering and was on for a few months. one corner is not in but glass present
 
well I think its because nobody can gurantee the lanes being open on the day. I thought it was lanes tbh but I'll go and give it a go anyway.

Think we need to sort one out but i'm out the running until end of May for anything
 
Work on the trialer starts again this evening!!

On a shiny concrete pad!! Woop!

Anyone have any uses for old wheels n tyres?? Someone mentioned they wanted some old rims to lower a landy so it can drive in a garage
 
jai_landrover said:
Work on the trialer starts again this evening!!

On a shiny concrete pad!! Woop!

Anyone have any uses for old wheels n tyres?? Someone mentioned they wanted some old rims to lower a landy so it can drive in a garage
Click to expand...

Hi Jai, are the wheels for tubed or tubeless tyres, I'm after some tubeless ones, cheers Kevin
 
The others are rusty old scrap tbh ok to drive on to get a car in a garage but I wouldn't even drive on them offroad as theyre rusty as heck!
 
Last edited:
Cheers Defenderdog1 for sorting my MOT out, got 2 new tyres for £110 and then the pass certificate, will get you a pint in the pub.
 
Right my front axle for the trialer isn't as it seems its a late series axle but has the earlier bearings and 24 spline outter shafts, The axles spyderman and I got a pair of I have stripped the rear one to pinch some bits and its a 10 spline :-( so not very happy.


On the plus side one Offside hub and brake assy all back together and brake pipes made and fitted. Its time to start on the nearside in between showers!
 
Fellas can anyone help, when my wheel bearing collapsed last week the spacer washer that sits between the outer race an the hub nut came out in two pieces. Does anyone have one kicking around? I'm thinking Jai here haha.
 
Hi lee is it the key way type?? if so yes loads of them or the one with a flat across type I should have here somewhere come eat whenever J
 




Getting there slowly we have front backplates/brakes/hubs/drums/wheels and tyres after some faffing getting them on the rims with pry bars! Gotta run copper pipe to the master cyolinder, fit a couple of split pins in the halfshaft nuts and add some shiney hun caps!
 
You must log in or register to reply here.

Similar threads

A
Hampshire Green Lane Trip 11th August.
2
Replies
26
Views
2K
Anaconda
A
G
Top 100 green lanes
2 3
Replies
46
Views
4K
Freddie17
Freddie17
A
Peak District lanes
Replies
8
Views
2K
Anaconda
A
ar1g3
P38A Looking for p38 parts in Kent area
Replies
13
Views
834
Datatek
Datatek
A
Non Scratchy Greenlane Trip Berkshire/Wiltshire
Replies
10
Views
3K
Anaconda
A