FFS "Jack, I really think you should seriously consider getting one from the scrapyard again"

Here we go again.... :doh::doh: Sooner i get away the better..
 
Hello boys and girls.... busy old thread i see still!!...

Been keeping up with a daily email to my phone even though I've not been on here for over a month!! Crazy busy with new job but all is good!...

Hopefully when things calm down a bit i'll be down for the pub meet to say hi!
 
Hello boys and girls.... busy old thread i see still!!...

Been trying to keep up with a daily email to my phone but it ran out of battery cause ive been stuck here for over a month!! Everyone says theyre too busy to help, so i've been trying to pull the disco out myself, but all is good!...

Hopefully when I get out i'll be down for the pub meet to say hi!

Edited for accuracy ;)
 
Jack,
Numax CV-X1000 I think is what I`ve got 2 of, both from Tayna. Next day delivery, about £70 each. Nothing better anywhere near the price.
 
Lol Been grinding out diff castings today to fit a P38 4 pin center and Ashcroft HD Crownwheel and pinion.

Casing has been fully sripped, ground out a wee bit. But I require somthing more meaty my hobby gringer is a wee bit slow going. I managed to get it to fit in and turn freely with a few mm of movement either side. Setting up the diff with the pinion in may need quite a bit more ground out to make it feasable. geting there I think iyt will work just loads more cleaning and grinding up to do.

Could do with a 240v Die grinder and bits might have to resort to some die grinder bits in the drill tomorrow if all else fails.
 
we need another centralish LZ Meet that way everyone can swap bits chat etc. Carpy did a great job last time but think he is nearer sheep land now days.
 

Similar threads