Your local Ikea might have some wooden dowels going spare.....I have done a TDI before and a daf paccar 4cyl, both of which were simpler than this, but this is ok apart from the snapped bolts so far. It's all stripped ready to take to the engineers tomorrow so I'll see what he says. Thinking I may make aluminium dowels then no one will be happy
Them paccar 4 pots are decent motors.I have done a TDI before and a daf paccar 4cyl, both of which were simpler than this, but this is ok apart from the snapped bolts so far. It's all stripped ready to take to the engineers tomorrow so I'll see what he says. Thinking I may make aluminium dowels then no one will be happy
no we dont, so cant agree with you on that one.Others disagree obviously, after all, it is a forum!!
yep had one on a BMW X5 that shattered, total twunts....Nobody at LR ever wondered that, they went on to make plastic inlet manifolds
I think the plastic dowels come in the Britpart head kits. Not sure Iād trust anything in their kits though for a cylinder head!
I didn't get any britpart
The place I got the head from only sells elring gasket sets so I have that
What mileage you on ?
they always reckoned the td5 would go for 500k miles without needing any major work! when did you last change the depression control valve?
I just had one arrive from you
oh that was you! I might owe you some Haribo then we'd run out the other day
The Haribo arrived today, you made my daughter very happy
You're not meant to share!The Haribo arrived today, you made my daughter very happy
Just hit you up for the next job too
I just saw that, I'm not in tomorrow but I'll nip in early and sort it. Getting dragged off for a half term day out! I have it on good authority Halfords are currently the best for the ball joint tool
Thank you! I'm running low on haribo's atm!
