Classic??
P28??
L320??
L322??
Year??
Assuming P38 -
Only the handbrake light or also the Traction Control and ABS Warning Lamp??....As these will come on too with a duff pump and accumulator...
If it is just the Handbrake Warning lamp, check the handbrake switch, fluid level and brake pad thickness....
A good introduction helps!!
P28??
L320??
L322??
Year??
Assuming P38 -
Only the handbrake light or also the Traction Control and ABS Warning Lamp??....As these will come on too with a duff pump and accumulator...
If it is just the Handbrake Warning lamp, check the handbrake switch, fluid level and brake pad thickness....
A good introduction helps!!
may not be related to the work youve done have you checked the switch that turns off the light on the hand brake lever
Got there first
Datatek
Well-Known Member
It say's P38 in the headerGot there first
I tell ya - my eyesight is getting worse...It say's P38 in the header
And fluid level and the Handbrake switch right??
If it stayed on after hand brake was released and now goes out, i would be looking at brake fluid level. Start engine and allow ABS pump to stop then fill to max level on tank. You cannot check fluid level if ABS pump has been stopped for any length of time, fluid bleeds back into tank and it will always look over full. If you fill it to max and car has been stood a while and pump not run it will be low after pump has run.
