D

David Leech

Well-Known Member
Series 3, How far out should my Button pop, Ladies and Gentlemen. Without further investigation I can only depress it about 1/8 inch (3mm). It appears quite stiff at that but does release from the ratchet. Obviously bench testing at the moment.....

51107277843_8f9a86287b_c.jpg
 
rob1miles said:
Squirt oil round it, then get a hide mallet and keep tapping it down gently, it will gradually come out more.
Click to expand...

I was at it today, cleaning the crud off. Dismantled the whole thing and to my surprise the button screwed off fairly easily. Cleaned and greased everything but when assembled the button is more or less in the same position, it's freer now though. I wonder if it's possible to screw the button on too 'tight', The only way I could gain a bit extra would be to unscrew the button a fraction. This is all 'bench work' so I'll wait and see when the time comes to actually fit it.
'Lands' are arriving this week Rob, I'm going to attempt that chisel trick.....
 
You must log in or register to reply here.

Similar threads

O
Body Alignment Help Needed
Replies
17
Views
3K
catman275
catman275
N
Wheel resistance
2
Replies
39
Views
3K
steve2286w
steve2286w
T
Gear lever gaiters
Replies
6
Views
902
lynall
L
xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
394
xDParis64
xDParis64
L
SOLD - Land Rover Ninety (Defender 90) 300TDi Auto soft-top
Replies
9
Views
5K
mondifa
M