P38Seb

P38Seb

Well-Known Member
Morning everyone.

In my ever continuing quest to make this 160,000 mile P38 a somewhat presentable example my attention has now turned to my tail lights, as you can see in the attached image there’s some filth settled to the base of the light. It’s not external as I’ve tried wiping it off to no avail.

Are these light disassemble-able or am I better looking for a replacement set?

TIA
 

Attachments

  • IMG_0665.jpeg
    IMG_0665.jpeg
    409.1 KB · Views: 89
Just buy a good one from a breaker.£40ish two minute job to swop. I slammed a walking stick in the tailgate and cracked mine.
 
Thanks all. The ones I’d seen elsewhere were costing a lot more.

I’ll take the ones in the link! Thanks!
 
P38Seb said:
So the lenses and coloured parts are able to be separated? I’d much rather give them a clean than just spend money!
Click to expand...
No I don't think so, just pour the water in through the bulb opening and swill it around then leave it for a while. Another swill and pour out. Might need more than one attempt and the water needs to be fairly hot, hand hot not boiling.
 
My rear tail lights are OK but the clear plastic over the rear number plate bulbs (tucked under the handgrip of the upper half of the tailgate) is almost completely black. I only discovered this when i needed to change one of the bulbs.
 
I cleaned mine the same way as Keith is suggesting, soak the inside with Fairy liquid and shake them vigorously. I made some thin long strips and wrapped cloth on the end to do the hard bits, then blow with an air gun to get the bits in the edges out. Mine are back to brand new now. Even if you buy from a breaker or flea bay odds are that they will also have crud inside
 
nigelbb said:
My rear tail lights are OK but the clear plastic over the rear number plate bulbs (tucked under the handgrip of the upper half of the tailgate) is almost completely black. I only discovered this when i needed to change one of the bulbs.
Click to expand...
Same process as cleaning the tail lights, the little weep holes in them get blocked and they get moss or mould growing inside, as with my tail lights my numberplate ones are back to new. A few years back I actually had an MOT fail notice because there was not sufficient illumination to the number plate, rather picky I thought at the time..............
 
P38Seb said:
So the lenses and coloured parts are able to be separated? I’d much rather give them a clean than just spend money!
Click to expand...
They cannot be separated unfortunately, the one thing to watch is that very often the double ended bolt/screw is very rusty (usually the visible one) the nut usually shears the bolt bit. You can extract the screw in bit and use a self tapper, I bought some spare fixings coz I'm a tad fussy..........
 
You must log in or register to reply here.

Similar threads

M
Reverse lights stuck on
Replies
5
Views
1K
Nunkie
N
Georgeblade
Disco 1 lights and dash lights dim when indicators are on.
2
Replies
28
Views
3K
Georgeblade
Georgeblade
D
New Style Tail/Stop Lights Problem .
2
Replies
28
Views
3K
dogdog1
D
Western Slope Rover
Classic Lost left rear tail light, clearance light and license plate light all at once.
Replies
18
Views
2K
Dippypud
Dippypud
VirusWar
[SOLVED] Tail lights
Replies
4
Views
659
andyfreelandy
andyfreelandy