anorakmark

Active Member

• Oct 2, 2011

• #1

Help needed please,
My Range Rover 1998, 2.5 DSE has developed an auto gearbox fault which I think may be a tempreture sensor.
Today after a 30 mile driver the alarm in the cabin came on and a message on the display reading the following. GEARBOX OVAHEAT, and another message underneath telling me to refer to owners manual.
I checked transmission fluid and its lovely and red not a burnt brown and was only changed 6000 miles ago inc filter.
I switched car of and left it for 5 hours, put keys in igniton to start and still have the alarm beep and the over heating message on disply. I switched off again and left for 2 hours and same fault.
I am assuming its a sensor fault as the gearbox is not overheating and surely after 5 hours if it had off it would have cooled down. can anybody advise if it could be a sensor as I can't clear the display of the fault and can't use the menu for speed limiter of trip compute as the error message is over riding the system.
If it is the sensor where on the box is it located, is it easy / difficult and cost?
Thanks all for your assistance in advance,.

 

wammers

No longer with us, RIP

Donater

• Oct 2, 2011

• #2

It Isn't on the box it's on the oil cooler on the V8 at least, where it is on the diesel Rave does not say as far as i can see..

 

Last edited: Oct 2, 2011

4x4landrover specialist

Banned

• Oct 2, 2011

• #3

gear box oil cooler senor is at cooler behind front bumper where spot lamp's would be on a petrol and are very common to fault

 

jamesmartin

Well-Known Member

• Oct 2, 2011

• #4

isnt in box on diesel either

 

anorakmark

Active Member

• Oct 2, 2011

• #5

Thanks guys, I have been informed that on the V8 you can access the sensor from the inside of the bonnet but the 2.5 Diesel oil cooler sensor is located behind the front bumper.
I am 99% sure it must be the sensor as the message is permanatly displayed even when box is stone cold.

 

vougese39

Well-Known Member

• Oct 3, 2011

• #6

The wires chaf on the panelling check first easy to pop bumper off and see

 

Datatek

Well-Known Member

• Oct 3, 2011

• #7

Yes, check the wiring before you buy a sensor.

 

anorakmark

Active Member

• Oct 3, 2011

• #8

Datatek said:

Yes, check the wiring before you buy a sensor.

Click to expand...

Hi Datatek,
I had a look underneath the front N'S and what seems to be the oil cooler are to electrical plugs I'm not sure if any of these two are for the gearbox sensor? I have been told that the sensor is only accessed by removing the front bumper first is this correct?. The two electrical connectors I saw, I detached and sprayed with electrical cleaner but the problem is still there.
The car had sat for 12 hours and I put keys in the ignition and straight away got the alarm and warning GEARBOX OVAHEAT, REFER TO USER MANUAL?
I called London Range Rover to day and roughtly quoted £45 for the sensor.

 

Datatek

Well-Known Member

• Oct 4, 2011

• #9

You sure you were looking at the oil cooler sensor and not the aircon?
For the sensor look at Island 4 x 4, Rimmer bros, Paddocks, P38 spares etc.

 

anorakmark

Active Member

• Oct 4, 2011

• #10

Hi datatek, yes i think your correct and i possibly was looking at the air con sensor, stupid me. Ok thanks for your kind assistance.

 

anorakmark

Active Member

• Oct 4, 2011

• #11

Whilst Im here and on about my gearbox sensor can anybody confirm if its an easy job, are there any special tools required. Also any clues on how to start removing the front bumper. Sorry to ask but Im a bit of a novice on some technical stuff.

 

Datatek

Well-Known Member

• Oct 4, 2011

• #12

anorakmark said:

Whilst Im here and on about my gearbox sensor can anybody confirm if its an easy job, are there any special tools required. Also any clues on how to start removing the front bumper. Sorry to ask but Im a bit of a novice on some technical stuff.

Click to expand...

You shouldn't need to remove the bumper. The oil cooler is quite accessable