Hi peps after wiping all errors from the fault codes there is one that just won't go away and that is canbus error in the eas the suspension is at normal ride height but I cannot adjust it as it also comes up air suspension inactive on the dash like I say the only error is the canbus any ideas would be very much appreciated
What is the code value or number? It's a comms fault from one module to another. Something is neither receiving or sending a signal.
Last edited:
Canbus fault 32
Henry_b
Think outside, no box required.
The can bus is just a pair of twisted wires 2.0 to 2.7v running from module to module. They fault due to an open circuit or high resistance pin or a loose plug i'd start looking at the ECU under the passenger seat, water ingress is common and reaks havoc, corroded pins etc
And what scanner are you using to read these faults?
And what scanner are you using to read these faults?
Go back to the last thing you did and check to see if the two wire canbus loom has been disturbed, cut or unraveled.
Where is the location please of these wires
Most of the info you need is in RAVE, but search for the later edition with l322 in it.
https://www.landyzone.co.uk/land-ro...lus-other-useful-info-on-range-rovers.322195/
https://www.landyzone.co.uk/land-ro...lus-other-useful-info-on-range-rovers.322195/
