Craigevo92

Member

• Aug 18, 2020

• #21

We also tryed plugging a nano com in for diagnostics and it couldn't get into the ecu is that because it is a 10p ecu and it wont read through the obd port ?

 

sierrafery

Well-Known Member

• Aug 18, 2020

• #22

No, nanocom should read everything unless the vehicle is immobilised.

 

tom1979

Well-Known Member

Full Member

• Jan 23, 2021

• #23

Craigevo92 said:

We also tryed plugging a nano com in for diagnostics and it couldn't get into the ecu is that because it is a 10p ecu and it wont read through the obd port ?

Click to expand...

did you get to the bottom of it?

 

Kenbo

Active Member

• Jan 23, 2021

• #24

Old thread and he hasn't been on since. Typically these people get a lot of very good advice and don't have the courtesy to report back on the result.
Sierrafery: very impressed with "interpunction" I thought my grammar was pretty good but that was a new one to me.

 

tom1979

Well-Known Member

Full Member

• Jan 23, 2021

• #25

Kenbo said:

Old thread and he hasn't been on since. Typically these people get a lot of very good advice and don't have the courtesy to report back on the result.
Sierrafery: very impressed with "interpunction" I thought my grammar was pretty good but that was a new one to me.

Click to expand...

Quite annoying really, I’ve had a few problems and always make sure to conclude the posts.

 

Craigevo92

Member

• Jan 25, 2021

• #26

Hi sorry haven't been getting emails to say people have replied yes it turnt out to be a bad engine bay fuse board replaced and all was fine thanks