D

Defender Chris

New Member
Hi all i have a problem with my disco 1 1996 300tdi, the ignition comes on as normal but when i try to crank it it dose nothing it sounds like there is a relay kicking in but nothing elce? The key fob fore the alarm works central locking ect. Any ideas any one????????????????
 
Also check the multi plugs under the dash i had this once and it turn out to be a loose plug next to the fuse box
 
thanks for the advice i will check all the plugs. i can start it by buypasing it and putting power straight to the starter via a switch but is not ideal. ive tryed a new ignition barrel but there was no change.
 
Try and crank it by the garage. Also maybe try and crank it by another running car, it might get the idea.
 
If the engine doesn't crank it could be immobilised, you can hear relays clacking then it could be a flat battery.
 
Defender Chris said:
thanks guys, its not the battery as ive puta new one on, and the car is a manual
Click to expand...

Unfortunatly you now have to check all of the starting circuit, from the battery to the switch to the motor and some the stuff in between may be to see why it's doesn't crank.
 
Possibly a dumb question, but have you tried locking it & then unlocking it with the remote?

All the Discos I've ever had have done this at least once or twice.

But if you think that's bad try Jeep, I've just unloaded a 97 grand Cherokee, 2.5td.
If you leave it more than a minute or two without either locking or starting it, when you restart it fires then immediately cuts out & you have to press unlock on the remote to reset. Add to that, that the starter won't work unless the clutch pedal is buried in the carpet & it's one of the most unfriendly vehicles to drive that I've ever owned, damn glad to see the back of it..
 
im still strugeling to get her to crank by the key. i thought that i might have a problem with the imobiliser so i bought a spider to buypass it, and still no joy, as i turn the key to the crank position i can hear the relays make a click wich sounds normal to me. as i said i have wired a seprate switch to the starter and it crankd no problem and runs fine. but its not the most ideal thing to have on. so has any one got any other ideas i could try?
 
Defender Chris said:
im still strugeling to get her to crank by the key. i thought that i might have a problem with the imobiliser so i bought a spider to buypass it, and still no joy, as i turn the key to the crank position i can hear the relays make a click wich sounds normal to me. as i said i have wired a seprate switch to the starter and it crankd no problem and runs fine. but its not the most ideal thing to have on. so has any one got any other ideas i could try?
Click to expand...

Is it just a single click you can hear ? if so try wriggling the spade connector on the starter motor. Mine did this and had me pulling my hair out until an RAC man sorted it :eek: Common fault.
 
is it the solenoid on the starter you can hear clicking, or a smaller relay in the passenger footwell clicking?
suspect the latter, in which case you need to investigate whether it has a spider or is controlled thru the mfu (multi function unit)
on the back of the injector pump, you either have 1 wire or 3 wires.
if 1, then its probably spider, if 3 then controlled thru mfu.

easies solution is find stater cable on ignition barrel, splice another to it and run that to starter solenoid.
 
You must log in or register to reply here.

Similar threads

S
1993 discovery alarm
Replies
4
Views
412
Scott120160
S
G
Td5 central locking (another one)
Replies
3
Views
670
sierrafery
sierrafery
L
DISCOVERY 1 OBD OR NOT OBD?? and REPLACEMENT KEY??
Replies
8
Views
788
discool
discool
Beretta man
Discovery new fob
Replies
6
Views
1K
sierrafery
sierrafery
G
Ignition Lights ?
Replies
3
Views
493
discool
discool