200tdi ayre
Well-Known Member
Pics ? Which ball joint ?
LeadFarmer
Well-Known Member
Drop arm ball joint? They are known to be a pig to remove. I paid a garage to replace mine.
200tdi ayre
Well-Known Member
Upload to photo bucket then copy the IMG link
****ting it on the rounded side of the frame usually breaks them free not on the joint itself, the metal surrounding it
****ting it on the rounded side of the frame usually breaks them free not on the joint itself, the metal surrounding it
I presume you've tried bashing it out from below. The bit its in is cast iron, so I think you could heat it up quite hot to get it out. Other option would be remove the swivel housing and drill it out. Will take a while though
Dan_Trials
Well-Known Member
I know this might not help but there is 2p next to your axle stand.
Dan_Trials
Well-Known Member
I take it you need to hit it down the way? What's probably happening is it's flexing so you're not getting a dead hit. Try and get something solid under it like a trolly jack jacked up hard against it.
West Slope Rover
Well-Known Member
Try the old school method of placing a hammer on one side of the arm where the bolt goes through and then giving the other side a few sharp wacks with another hammer. The resulting shock often will pop the thing out.
Last edited:
Dan_Trials
Well-Known Member
Yes because this gives it a dead blow, although what you describe is a different use of the method to what I suggested
90maniac
Active Member
Haha i cant see one but i shall investigate when i go over in a min
West Slope Rover
Well-Known Member
I don't think so. What I mean is to smack the arm itself on the sides of the arm on either side of the stuck ball joint bolt, not the top or bottom of it. Nor do you whack the stuck bolt itself.
West Slope Rover
Well-Known Member
Sort of. More like setting a hammer up tight to one side, and then striking a blow to the other side.
