Used an old race to drift new ones in.

One hub nut didn't take much force to remove the play but the other side was quite difficult. Is this normal? If it knackers another set I might replace the the stub axle as well.. Would that help?
 
this is what happend to my stub axle when wheel bearing collapsed..and yes the hub nut is still in place on the end although its round..i was lucky wheel didnt completely come off

hub4.png
 
After checking the rear ones (I did them 4months ago) not the slightest bit of play. So it's something to do with the stub axle or something. Ideas?

Also when you get new discs does it come with the bearing housing.
Or is that separate?
 

Similar threads